輸送帶使用之前為了能夠使用中更好的使用，就需要好好的進行檢查，那么有怎樣的檢查方法要知道的呢？下面就來看看吧。
Before using the conveyor belt, in order to be able to use the better use, it is necessary to have a good inspection, so what kind of inspection method to know? Here's a look.
山東輸送帶表面上的明疤深度不能大于一毫米，單位面積覆蓋層上的氣泡、脫層總面積不得規定值；耳膠缺膠、裂開、海綿及起泡等缺陷總長度不能超過總帶長的百分之一；表面不得露膠布；不得有鉸鏈型帶端膠布拉破。一旦超過了規定的范圍，都要及時進行修繕。
The depth of open scar on the surface of Shandong conveyor belt shall not be greater than one millimeter, and the total area of bubble and delamination on the covering layer of unit area shall not be specified; The total length of defects such as lack of glue, split, sponge and blister should not exceed 1% of the total length of the tape. Adhesive cloth shall not be exposed on the surface; No broken hinge tape with end. Once it exceeds the prescribed range, it should be repaired in time.
檢測完這些外觀參數，還要檢測輸送帶的抗靜電性能的優劣。由于輸送帶橫向排列有高彈鋼條，不容易切割，所以在測試的時候可以沿著輸送帶縱向每隔三百毫米將牽引帶全部切割下來。
After detecting these appearance parameters, the advantages and disadvantages of the antistatic performance of the conveyor belt should also be detected. Because the conveyor belt is horizontally arranged with high elastic steel bars, it is not easy to cut, so in the test, all the traction belt can be cut down every 300 mm along the conveyor belt longitudinal.
將切割好的試樣用蘸有蒸餾水的干凈綢布或紗布擦洗干凈，將試件放在一塊稍大一點的絕緣平板上，涂煳的一面朝上，將擦凈的銅電極基面放在上面，接上電源后就可以測量其表面電阻了。
The cut sample is dipped in distilled water with clean silk cloth or gauze scrub clean, specimen on a slightly larger insulating plate, the painted side is up, will wipe the copper electrode base surface on the above, after connected to the power supply can measure its surface resistance.
分幾次完成同樣的試驗，然后取其平均值就可以說明輸送帶的抗靜電行怎么樣了。
Perform the same test several times, and then take its average value to show how the conveyor belt's antistatic behavior is.
Shandong conveyor belt before use to carry out strict inspection! In addition, regular maintenance of its maintenance work is also essential, you can come to the website www.jsamsung.com.cn for consultation.
聯系微信