傳送帶在使用過程中會伸長，其中一部分是彈性伸長，在外力撤銷后能恢復原狀，另一部分是骨架材料的編制收縮的伸長量，這一部分是無法恢復的。
The conveyor belt will stretch during use. One part is elastic elongation, which can be restored to its original state after the external force is withdrawn. The other part is the elongation of the weaving shrinkage of the skeleton material, which cannot be restored.
傳送帶運行速度一般不宜大于2.5m/s，塊頭大，磨損性大的物料和使用固定梨的卸料裝置應盡量采用低速。
Generally, the running speed of the conveyor belt should not be greater than 2.5m/s. Low speed should be used as far as possible for large and abrasive materials and unloading devices using fixed pears.
給料方向應順傳送帶的運行方向，為減小物料下落時對傳送帶的沖擊應采溜槽，減小物料落差距離；傳送帶受料段，應縮短托輥間距和采用緩沖托輥為漏料，傳送帶順應采用柔軟適度的擋料板，以免檔料板過硬，刮破傳送帶的帶面。
The feeding direction shall be along the running direction of the conveyor belt. In order to reduce the impact on the conveyor belt when the material falls, a chute shall be used to reduce the drop distance of the material; In the material receiving section of the conveyor belt, the idler spacing shall be shortened and the buffer idler shall be used as the material leakage. The conveyor belt shall adopt a soft and appropriate baffle plate to prevent the baffle plate from being too hard and scratching the belt surface of the conveyor belt.
傳送帶在使用時，如有托輥缺少，應及時添加及修好；托輥被物料覆蓋，造成回轉不靈，防止漏料卡于滾筒與膠帶之間，注意傳送帶活動部分的潤滑，但不得油污傳送帶。
When the conveyor belt is in use, if there is a lack of idler, it should be added and repaired in time; The idlers are covered with materials, causing poor rotation and preventing material leakage from being stuck between the drum and the belt. Pay attention to the lubrication of the moving part of the conveyor belt, but do not oil the conveyor belt.
避免傳送帶遭受機架，支柱或塊狀物料的阻滯，防止碰破扯裂，發現傳送帶局部破損時，應用人造棉及時修補，以免擴大。
Prevent the conveyor belt from being blocked by the frame, support or block materials, and prevent it from being broken and torn. When the conveyor belt is found to be partially damaged, it shall be repaired with artificial cotton in time to avoid expansion.
準確說明具體物料的名稱、性質。特別是粒度、溫度、可否具有酸、堿等腐蝕性和特殊要求。如有需要要說明使用的溫度。
Accurately describe the name and nature of specific materials. In particular, the particle size, temperature, acid, alkali and other corrosivity and special requirements. If necessary, specify the temperature used.
說明具體應用場合，要求規格(寬度、長度、層數、厚度等)，尤其是耐熱傳送帶的使用溫度與運量大小。
Specify the specific application occasions, required specifications (width, length, number of layers, thickness, etc.), especially the service temperature and traffic volume of the heat-resistant conveyor belt.
傳送帶在運輸和貯存中，應保持清潔避免陽光直射或雨雪浸淋，防止與酸、堿、油類、有機溶劑等物質接觸，并距離發熱裝置一米以外。
During transportation and storage, the conveyor belt shall be kept clean from direct sunlight or rain and snow, and shall not contact with acids, alkalis, oils, organic solvents and other substances, and shall be more than one meter away from the heating device.
此外避免托輥被物料覆蓋，造成回轉不靈，防止漏料卡于滾筒與膠帶之間，注意活動部分的潤滑，但不得油污傳送帶。力求避免傳送帶負荷啟動。
山東傳送帶發生跑偏時，應及時采取措施糾正。發現傳送帶局部損傷應及時修補，以免擴大。避免帆布傳送帶遭受機架、支柱或塊狀物料的阻滯，防止碰破扯裂。
In addition, prevent the idler from being covered by materials, resulting in poor rotation, prevent material leakage from being stuck between the roller and the belt, and pay attention to the lubrication of the moving part, but do not oil the conveyor belt. Try to avoid belt load starting. In case of deviation of Shandong conveyor belt, measures shall be taken to correct it in time. Local damage of the conveyor belt shall be repaired in time to avoid expansion. The canvas conveyor belt shall be prevented from being blocked by the frame, support or block materials to prevent it from being broken and torn.
The above is the relevant content of the question answer. I hope it can help you. If you still have any questions about this problem, you are welcome to follow our website http://www.jsamsung.com.cn And consult our staff, will serve you wholeheartedly.
聯系微信
